PROJECT CALCULATOR

Rebar Grid Quantity Calculator

Estimate bar lines in a simple two-direction grid. This is a purchasing sketch, not a reinforcement design.

ENTER YOUR MEASUREMENTS

Spacing and edge inset are inputs from your plan. No bar size or structural load is selected here.

Exact quantity—
Order estimate—
Additional measure—
Planning measure—

Advertisements

How the calculation works

Clear length and width equal overall dimensions minus two edge insets. Number of bars parallel to length = ceil(clear width ÷ spacing) + 1; bars parallel to width = ceil(clear length ÷ spacing) + 1. Linear feet = each count × its clear bar length.

Worked example

For a 20 × 10 ft grid, 12 in maximum spacing and 3 in edge inset, estimate 11 lengthwise lines and 21 widthwise lines. That totals about 414 linear feet. With 10% extra, a simple length division suggests 23 stock bars at 20 ft each.

Before you order

Stock-bar count is only linear feet divided by bar length. Cutting layout, lap splices, hooks, supports, openings and structural requirements can increase it. Have the bar schedule and placement checked against plans.

Review the calculation method and source notes, then use the supplier checklist before placing an order.

How to interpret the bar count

The tool counts straight grid lines in two directions after subtracting the edge inset. It then totals their clear lengths, adds your allowance and divides by stock-bar length for an approximate purchase count. It does not calculate lap splice requirements, cutting waste by piece, chairs or vertical bars.

For example, a 10 × 10 ft slab with a 3 in edge inset leaves 9.5 ft of clear length in each direction. At 12 in maximum spacing, each direction needs 11 grid lines, so the straight grid contains about 209 linear ft before allowance. Layout and reinforcement size must follow project documents.

Questions before you order

Does the stock bar count include lap splices?

No. It divides total linear feet by stock length. Add splice and cut planning separately.

Is the spacing a structural recommendation?

No. It is an input for estimating quantity, not a design recommendation.

Does the tool count chairs or tie wire?

No. It estimates straight rebar only.

Continue planning

Second example: spacing sensitivity

For a 10 × 20 ft slab, a grid specified at 12 in spacing has more bar lines than the same plan at 18 in spacing. The spacing choice comes from the project design; this calculator only translates it into a count. Confirm how the edge offset and end bars are handled before ordering. A one-line difference in each direction can represent a substantial extra stock length.

The displayed total is not a fabrication schedule. Bar stock length, lap length, bends, dowels, openings and supports can change purchases. Sketch both directions and compare the counted positions to the approved reinforcement detail. If the drawing specifies welded wire mesh instead, do not assume the bar count is a valid substitute.

Read before you order

Rebar grid vs wire mesh · Planning slab thickness

Review bar placement assumptions

When checking a grid result, sketch the first and last bar lines in each direction. The count depends on whether bars are placed at the edges or offset inward, so a spacing number alone is not a complete layout. Confirm stock lengths and lap requirements with the drawing and supplier. The estimate can highlight an unexpectedly large or small count, but it should never be used to decide a different spacing or bar size from the approved specification.

Content and calculator by pourmeasure. Formula and assumption notes: methodology and sources. Updated October 2026. No independent engineering review is claimed.